F 250 4WD Super Duty V10-6.8L (2002)
1. NOTE: If the CBV assembly was removed, refer to Cooler Bypass Valve for the installation procedure.
Install and connect the fluid cooler tube(s).
2. Install the fluid cooler tubes in the front and rear cooler line case fittings.
3. CAUTION: Install a new inline transmission fluid filter (XC3Z-7B155-BA) as part of a transmission overhaul or exchange. If the vehicle was not
equipped with an inline fluid filter, install a new inline transmission fluid filter kit (XC3Z-7B155-AA) according to the instructions supplied with
the kit as part of a transmission overhaul or exchange.
CAUTION: Failure to follow the instructions supplied with the inline transmission fluid filter kit can cause transmission damage.
Verify that the flow arrow on the filter points toward the transmission.
If the vehicle was equipped with an inline fluid filter install a new inline transmission fluid filter (XC3Z-7B155-BA). If the vehicle was not
equipped with an inline fluid filter install a new inline transmission fluid filter kit (XC3Z-7B155-AA). Carry out the transmission fluid cooler flow
test procedure to verify that there is correct fluid flow through the new inline fluid filter.
4. Position the air deflector and install the bolts
