F 250 4WD Super Duty V10-6.8L (2002)
5. Using a suitable press, Remove the bearing from the driveshaft.
6. Using a suitable press, remove the dust slinger.
7. NOTE: Clean grease deposits, dirt and rust from the stub shaft.
NOTE: Inspect the stub shaft splines for nicks, gouges, or burrs. Remove with a file or emery cloth.
NOTE: The driveshaft center bearing bracket must be installed with the deep flange rearward.
To assemble, reverse the disassembly procedure.
-
Lubricate the stub shaft spline with Premium Long-Life Grease XG-1-C or equivalent meeting Ford specification ESA-M1C75-B.