F 250 4WD Super Duty V10-6.8L VIN S (2001)
4. Tighten the RH rear bleeder screw, and disconnect the waste line.
5. Repeat Steps 2, 3 and 4 for the LH rear bleeder screw, the RH front disc brake caliper bleeder screw, and the LH front disc brake caliper bleeder
screw, in that order.
6. Connect the scan tool DCL cable adapter into the vehicle Data Link Connector (DLC) under the dash, and follow the scan tool instructions.
7. Repeat the system bleed procedure as outlined in Steps 1 through 5.
Hydro-Boost Bleeding
Hydro-Boost Bleeding
1. NOTE: The Hydro-Boost power brake booster is generally self-bleeding, and the following procedure will normally bleed the air from the power
brake booster. Normal operation of the vehicle will further remove any additional trapped air.
Fill the power steering oil reservoir with MERCON (R) Multi-Purpose ATF XT-2-QDX or MERCON (R) equivalent.
