F 250 4WD Super Duty V10-6.8L VIN S (2001)
Brake Master Cylinder: Service and Repair
Brake Fluid Reservoir
RESERVOIR
Removal
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake
fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water
and induce vomiting. Get medical attention immediately.
1. Disconnect the brake master cylinder fluid level switch.
2. Use a suitable suction device to drain the brake master cylinder reservoir.
3. Carefully pry up on the brake master cylinder reservoir to remove.
Installation
1. NOTE: Whenever replacing the brake master cylinder reservoir, replace the grommets.
Install the brake master cylinder reservoir.
1
Lubricate the two grommets with High Performance DOT 3 Motor Vehicle Brake Fluid C6AZ-19542-AB or equivalent fluid meeting Ford
specification ESA-M6C25-A, and insert the grommets into the brake master cylinder.
2
Press the brake master cylinder reservoir into the grommets until it is fully seated.
3
Connect the brake master cylinder fluid level switch.
4
Fill the brake master cylinder reservoir with clean High Performance DOT 3 Motor Vehicle Brake Fluid C6AZ-19542-AB or equivalent fluid
meeting Ford specification ESA-M6C25-A.
