F 250 4WD Super Duty V10-6.8L VIN S (2001)
1. Follow the removal procedure in reverse order.
CAUTION: Position the temperature blend door manually to properly align the actuator and the door. Do not power the actuator electrically. If it
is not engaged with the temperature blend door, damage to the actuator can occur.
Auxiliary Climate Control
REMOVAL
NOTE: The blend door actuator is shown; the mode door actuator is similar.
1. Remove the third row seat.
2. Position the RH rear quarter trim panel aside.
3. Remove the blend door actuator.
1
Disconnect the connector.
2
Remove the screws.
3
Remove the blend door actuator.
INSTALLATION
1. To install, reverse the removal procedure.
