F 250 4WD Super Duty V10-6.8L VIN S (2001)
Headlamp Bulb: Service and Repair
Sealed Beam
REMOVAL
1. Remove the parking lamp assembly.
1
Remove the parking lamp bolts.
2
Position the parking lamp assembly so the electrical connectors can be accessed.
3
Disconnect the electrical connectors.
NOTE: The side marker lamp and parking lamp are one piece. Do not pull on the side marker to pull the assembly out.
2. Remove the headlamp bezel.
1
Remove the upper bolts.
2
Remove the lower bolts.
3
Remove the headlamp bezel.
3. Remove the headlamp.
1
Remove the headlamp retaining ring screws.
2
Remove the headlamp retaining ring.
3
Position the headlamp so the electrical connector can be accessed.
4
Disconnect the electrical connector.
INSTALLATION
1. To install, reverse the removal procedure.
