F 250 4WD Super Duty V10-6.8L VIN S (2001)
Alignment: Service and Repair
Lean Correction
Front
Lean Correction - Front, F-2-50, F-350, 4x4 and F-450, F-550
1. NOTE: Front side lean can be adjusted approximately 1.0 mm (3/8 inch) by installing shim D7TZ-5742-A on the low side. A vehicle that is low
at the front can be raised by installing shims at both sides.
Raise and support the vehicle.
2. Support the axle.
3. Remove and discard the four nuts and two U-bolts.
4. Separate the front axle from the springs.
5. Turn the shim so the recess is facing upward.
