F 250 4WD Super Duty V10-6.8L VIN S (2001)
5. Remove the nuts and separate the MAF sensor from the MAF sensor plate.
INSTALLATION
1. To install, reverse the removal procedure.
CAUTION: The grommet used to seal the engine air cleaner housing at the extension harness must be fully seated. Failure to do so will result in
unmetered air entering the engine.
NOTE:
^
Use the alignment notch to properly align the inlet side and the outlet side of the engine air cleaner.
^
When reinstalling the Mass Air Flow (MAF) sensor, make sure wires are not trapped behind MAF. Make sure electrical connector is pointing
up on installation.
