F 250 4WD Super Duty V10-6.8L VIN S (2001)
Fuel Tank Pressure Sensor: Service and Repair
REMOVAL
1. Remove the fuel tank.
2. Remove the fuel tank pressure sensor.
^
Disconnect the electrical connector.
^
Press down and rotate the fuel tank pressure sensor counterclockwise and remove it from the fuel tank.
CAUTION: The fuel tank pressure sensor must be disengaged from the fuel tank before it can be removed. Push down while rotating the sensor
counterclockwise to disengage it from the fuel tank. Failure to do so can cause damage to the fuel tank pressure sensor or the fuel tank.
INSTALLATION
1. To install, reverse the removal procedure.
^
Carry out the system leak test. See: Emission Control Systems/Evaporative Emissions System/Testing and Inspection/Component Tests and
General Diagnostics/Evaporative Emission System Leak Test
^
Carry out the evaporative emission repair verification drive cycle. See: Emission Control Systems/Evaporative Emissions System/Testing and
Inspection/Component Tests and General Diagnostics/Evaporative Emission Repair Verification Drive Cycle
