F 250 4WD Super Duty V10-6.8L VIN S (2001)
1
Position the PATS transmitter.
2
Install the PATS transmitter retaining screw.
9. Install the upper steering column shroud.
10. Install the ignition switch lock cylinder.
^
Position the ignition switch lock cylinder to the RUN position.
^
Insert the ignition switch lock cylinder into the steering column.
^
Make sure the ignition switch lock cylinder is fully seated and aligned in the interlocking washer before turning the key to the OFF position.
^
Make sure the ignition switch lock cylinder retaining pin is seated in the hole in the steering column.
^
Rotate the ignition switch lock cylinder through all positions to verify operation.
11. Install the lower steering column shroud.
1
Position the lower steering column shroud.
2
Install the screws.
