F 250 4WD Super Duty V10-6.8L VIN S (2001)
1. Install the front safety belt retractor.
1
Position the front safety belt retractor to the B-pillar.
2
Using the special tool 501-010 (T77L-2100-A), install the bolt.
CAUTION: Do not remove the shipping clip until the safety belt guide is secured in position. Allowing the safety belt to be retracted further into
the safety belt retractor may cause the safety belt retractor to lock and not release the safety belt.
2. Route the safety belt anchor and guide through the B-pillar trim panel.
3. Install the shoulder belt guide.
1
Position the B-pillar trim panel to the body and push in at the top securing only those retainers.
2
Position the shoulder belt guide to the height adjuster.
3
Install the retaining nut.
4
Close the shoulder belt guide cover.
NOTE:
^
Do not secure the lower section of the B-pillar trim panel as the shipping clip will need to be removed from the safety belt retractor later.
^
Make sure the safety belt webbing is not twisted prior to installation.
4. Remove the shipping clip from the safety belt retractor.
5. Push in on the B-pillar trim panel, securing the remaining retaining clips.
