F 250 4WD Super Duty V10-6.8L VIN S (2001)
5. NOTE: Do not loosen the castellated nut to install the cotter pin.
Install the cotter pin into the upper ball joint.
1. Tighten the upper ball joint castellated nut.
2. Install the cotter pin. If necessary, tighten the castellated nut until the cotter pin can be installed.
6. Tighten the lower ball joint nut to 204 Nm (150 lb-ft).
7. Install the tie-rod end onto the wheel knuckle.
1. Position the tie-rod end into the wheel knuckle.
2. Install and tighten the castellated nut.
3. Install the cotter pin.
8. Install the new main seal onto the axle shaft.
