F 250 4WD Super Duty V10-6.8L VIN S (2001)
22. Back off the adjusting screw 1-1/2 turns and tighten the sealing nut. Tighten the sealing nut to specification.
23. Check the reservoir and fill if required.
24. WARNING: The length of the adjusting screw beyond the nut must be no more than 1-1/16 inch for correct thread engagement.
NOTE: The length of the adjusting screw beyond the sealing nut may be different for each vehicle.
Set the main TAS gear using the procedures described above. Leave the adjusting screws on the rotary cylinders in place as described above after
the poppets on the main gear have been reset.
25. Dower the vehicle.
