F 250 4WD Super Duty V10-6.8L VIN S (2001)
1. Follow the removal procedure in reverse order.
-
Install a new cotter pin.
2. Check the toe-in and clear vision settings.
RH
Tie Rod End - Outer, RH, F-250, F-350, 4x4, and F-450, F-550
Special Tool(s)
Special Tool(s)
Removal
NOTE: Replace the tie rod end if the ball stud is loose in the socket or the tie rod end is bent. Replace the front suspension steering ball stud dust seal
if any nicks, cuts or tears are present. Do not attempt to straighten a bent toe rod end.
1. Position and lock the wheels in the straight-forward position. Raise and support the vehicle.
2. Remove the wheel.
3. Loosen the adjusting sleeve clamps.
