F 250 4WD Super Duty V10-6.8L VIN S (2001)
2. CAUTION: Damage will occur to the rubber-coated sealing washers and transmission fluid will leak if the cooler line case fitting are
over-tightened.
NOTE: Align the rubber-coated sealing washers while installing CBV assembly on the transmission case.
Install the CBV assembly.
3. Install the fluid cooler tubes in the front and rear cooler line case fittings.
4. CAUTION: Install a new inline transmission fluid filter (XC3Z-7B155-BA) every 48,000 km (30,000 miles) and always as part of a transmission
overhaul or exchange. If the vehicle was not equipped with an inline fluid filter install a new inline transmission fluid filter kit (XC3Z-7Bl55-AA)
according to the instructions supplied with the kit as part of a transmission overhaul or exchange.
CAUTION: Failure to follow the instructions supplied with the inline transmission fluid filter kit can cause transmission damage.
Verify that the flow arrow on the filter points toward the transmission.
Install a new inline transmission fluid filter (XC3Z-7B155-BA). If the vehicle was not equipped with an inline fluid filter install a new inline
