F 250 4WD Super Duty V10-6.8L VIN S (2001)
4. Remove the Digital Transmission (TR) sensor.
1
Remove the bolts.
2
Remove the digital Transmission Range (TR) sensor.
5. NOTE: A No. 53 drill bit (1/16 inch) can be used instead to remove the manual lever shaft retaining pin.
Using the special tool, remove the manual lever shaft retaining pin.
6. CAUTION: Be careful not to damage the manual control lever bore.
NOTE: The manual control lever and manual control lever shaft are one piece.
NOTE: Use a crescent wrench on the manual control lever or outer flats of manual control lever shaft assembly when removing the inner manual
valve detent lever nut.
Remove the manual control lever shaft assembly.
1
Remove the inner manual valve nut.
2
Remove the inner manual valve detent lever.
3
Remove the parking pawl actuating rod.
4
Remove the manual control lever shaft assembly.
