F 250 4WD Super Duty V10-6.8L VIN S (2001)
11. Remove the clutch hydraulic reservoir from the wiring tray and separate the clutch hydraulic tube from the brake master cylinder assembly.
Position the clutch hydraulic reservoir aside.
12. CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, wash the surface with
water immediately.
Remove the clutch hydraulic system from the vehicle.
13. Clean the clutch hydraulic system components to prevent contaminants from entering the hydraulic system.
14. CAUTION: Place a suitable container under the clutch master cylinder.
Disconnect the hydraulic tube from the clutch master cylinder.
1
Using a 3/32-inch punch and a hammer, drive out the roll pin, and discard it.
2
Disconnect the hydraulic tube from the clutch master cylinder.
15. NOTE: Sometimes the O-ring seal will remain inside the clutch master cylinder.
Remove the O-ring seal from the end of the. hydraulic tube, and discard it. Cap the open end of the hydraulic tube.
Installation
