F 250 4WD Super Duty V10-6.8L VIN S (2001)
7. CAUTION: Do not damage the differential ring gear and pinion.
Using the special tool, carefully position the differential subassembly into the carrier.
8. CAUTION: The bearing cups must seat on the differential side bearings.
CAUTION: Align the match marks.
Install the differential bearing caps.
1
Position the bearing cap onto the leg.
2
CAUTION: The bolt threads must be clean.
Apply Thread lock 262 E2FZ-I 9554-B or equivalent meeting Ford specification WSK-M2G351 -A6 to the bolt threads, and install the bolts.
^
Tighten the bolts enough to eliminate visible space between the bearing cap and leg. Do not tighten the bolts to the appropriate torque at
this time.
9. CAUTION: Align the differential assembly within the bearing bores before applying preload or damage to the bearings will result.
Install the differential bearing adjusting rings.
^
Tighten both adjusting rings until there is zero end play, and some backlash between the differential ring gear and pinion. Make sure the
adjusting ring tooth aligns so that installation of the adjusting ring lock is possible.
