F 250 4WD Super Duty V10-6.8L VIN S (2001)
3. Seat the outer pinion bearing on the pinion.
1
Seat the inner pinion bearing into the cup by positioning a 152.4 x 152.4 x 152.4 mm (6 x 6 x 6 inch) block of wood under the pinion.
2
Place the original pinion preload spacer onto the pinion.
3
Place the outer pinion bearing onto the pinion.
4
Using a suitable press, seat the outer bearing on the pinion.
4. NOTE: Do not install the pinion seal at this time.
Using the special tool, install the pinion flange.