F 250 4WD Super Duty V10-6.8L VIN S (2001)
2. NOTE: To maintain driveline balance, mark the driveshaft components so they can be reinstalled in their original positions.
Disconnect the driveshaft at the rear axle, and position it aside.
3. NOTE: Index-mark the flange (end yoke for Motorhome) to the pinion shaft.
While using a suitable too[ to prevent the flange or yoke from turning, remove the pinion nut.
4. Using the 2 Jaw Puller, remove the flange or yoke.
5. Using the Bushing Remover and the Slide Hammer, remove the pinion seal.
6. Clean the rear axle pinion seal seat.
Installation
