F 250 4WD Super Duty V10-6.8L VIN S (2001)
3. Position the opposite bearing cup on the spider trunion.
4. Using the special tool, press the bearing cup to just below the snap ring groove.
5. Install the new snap ring.
6. Using the special tool, press the opposite bearing cup to just below the snap ring groove.
7. Install the new snap ring.
8. NOTE: Align the index marks made during disassembly.
Position the driveshaft center yoke on the spider.
9. Using the special tool, press the bearing cups into position.
^
Install the snap rings.