F 250 4WD Super Duty V10-6.8L VIN S (2001)
Transfer Case Actuator: Service and Repair
Gear motor Encorder Assembly
Removal and Installation
1. Set the mode select switch to the 4X4 HIGH position.
2. Raise and support the vehicle.
3. Disconnect the gear motor encoder assembly harness connectors.
4. Remove the three bolts and the gear motor encoder assembly.
5. Remove the grease from the motor adapter and check for any nicks or burrs. If any damage is found, repair or install a new adapter as necessary.
6. To install, reverse the removal procedure.
^
Apply a coat of Multi-Purpose Grease DOAZ-19584-AA or equivalent meeting Ford specifications ESB-MlC93-B to the new motor adapter.
