F 250 4WD Super Duty V10-6.8L VIN S (2001)
Wiper Motor: Testing and Inspection
Component Test
Windshield Wiper Motor
CAUTION: Do not handle the windshield wiper motor abusively when diagnosing the wiper operations. Failure to follow this caution may result in
damage to the motor magnets and will make the windshield wiper motor inoperative. Rough handling of new replacement windshield wiper motors may
also damage the motor magnets.
Use Alternator, Regulator, Battery And Starter Tester (ARBST) to test the wiper motor on the vehicle.
To test the wiper motor, disconnect the windshield wiper mounting arm and pivot shaft from the windshield wiper motor.
Disconnect the wiper motor. Connect the (1) green lead from the (2) ARBST to the battery negative (-) post. Connect the (3) red lead from the ARBST
to the wiper motor (4) common brush terminal (terminal 3).
Test the low speed mode by connecting a (5) cable from the battery positive (+) post to the (6) low speed brush terminal (terminal 4) and measure the
current draw. If the current draw is greater than 3.5 amperes, install a new windshield wiper motor.
Test the high speed mode by connecting a cable from the battery positive (+) post to the (7) high speed brush terminal (terminal S) and measure the
current draw. If the current draw is greater than 5.5 amperes, install a new windshield wiper motor.
