F 250 4WD Super Duty V10-6.8L VIN Y (2006)
Front Door Latch: Service and Repair
Door Latch Remote Control - SuperCab
DOOR LATCH REMOTE CONTROL - SUPERCAB
Removal and Installation
NOTE: The RH door is shown, the LH door is similar.
1. Remove the rear speaker.
2. Position the watershield aside.
3. Remove 3 upper rear door latch screws.
-
To install, tighten to 12 Nm (9 lb-ft).
4. Remove 3 lower rear door latch screws.
-
To install, tighten to 12 Nm (9 lb-ft).
5. CAUTION: When drilling out the latch remote control rivets, do not oversize the holes in the door sheet metal. Make sure not to exceed
a 6.35 mm (0.25 in) drill bit.
Remove the rear door latch remote control.
1
Disconnect the actuating rods.
2
Remove the rivets.
6. To install, reverse the removal procedure.