F 250 4WD Super Duty V10-6.8L VIN Y (2006)
CAUTION: When replacing either the HCU or the anti-lock brake system (ABS) module individually, make sure that the number of coils (metal
cans) in the ABS module equals the number of valves in the HCU. This is an additional method of verifying that the correct replacement part number
has been selected.
1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. Push the lock forward and release the ABS electrical connector.
3. NOTE: Plug each open port to prevent brake fluid from spilling.
Disconnect the hydraulic brake line fittings.
^
To install M 10 fittings, tighten to 17 Nm (13 ft. lbs.).
^
To install M12 fittings, tighten to 25 Nm (18 ft. lbs.).
4. Remove the 3 bolts and the HCU and bracket assembly.
^
To install, tighten to 20 Nm (15 ft. lbs.).
5. Remove the 2 HCU bolts from the bracket and remove the HCU.
^
To install, tighten to 11 Nm (8 ft. lbs.).
6. To install, reverse the removal procedure.
^
Bleed the brake system.
