F 250 4WD Super Duty V10-6.8L VIN Y (2006)
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the brake caliper flow bolt and discard the 2 copper washers.
^
To install, tighten to 35 Nm (26 ft. lbs.).
3. CAUTION: Do not pry in the caliper sight hole to retract the pistons, as this can damage the pistons and boots.
Remove the 2 brake caliper bolts and the caliper.
^
To install (F-250, F-350 single rear wheel caliper), tighten to 35 Nm (26 ft. lbs.).
^
To install (F-350 dual rear wheel caliper), tighten to 76 Nm (56 ft. lbs.).
^
To install (F-450, F-550 dual rear wheel caliper), tighten to 62 Nm (46 ft. lbs.).
4. To install, reverse the removal procedure.
^
Bleed the caliper.