F 250 4WD Super Duty V10-6.8L VIN Y (2006)
Engine Block Heater: Service and Repair
Block Heater - Gasoline Engines
Material
Removal and Installation
1. Drain the engine cooling system.
2. CAUTION: Do not loosen the block heater retaining screw more than necessary for removal.
Loosen the block heater retaining screw and remove the block heater.
^
To install, tighten to 2 Nm (18 inch lbs.).
3. NOTE: Route the block heater power cable away from hot or rotating components, or damage to the cable can occur.
To install, reverse the removal procedure.