F 250 4WD Super Duty V10-6.8L VIN Y (2006)
7. Disconnect the oil cooler coolant hoses from the oil cooler and position it aside.
8. Remove and discard the engine oil filter.
9. CAUTION: If metal or aluminum foreign material is present in the oil cooler, mechanical concerns exist.
Remove and discard the engine oil cooler.
^
Install a new oil cooler.
^
To install, tighten to 58 Nm (43 ft. lbs.).
10. Disconnect the engine oil pressure (EOP) sensor electrical connector.
11. Remove the EOP sensor.
^
To install, tighten to 18 Nm (13 ft. lbs.).
12. Remove the oil filter adapter nut.
^
To install, tighten to 48 Nm (35 ft. lbs.).
13. Remove the 4 bolts and the oil filter adapter.
^
To install, tighten to 25 Nm (18 ft. lbs.).
14. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These may cause
scratches and gouges resulting in leak paths. Use a plastic scraper to clean the sealing surfaces.
Remove and discard the oil filter adapter gasket. Clean the sealing surfaces with silicone gasket remover and metal surface prep. Follow the
directions on the packaging. Inspect the mating surfaces.
15. To install, reverse the removal procedure.
