F 250 4WD Super Duty V10-6.8L VIN Y (2006)
longer. Failure to follow this procedure can cause future oil leakage.
Apply silicone gasket and sealant at the crankshaft rear seal retainer plate-to-cylinder block sealing surface.
5. NOTE: If not secured within 4 minutes, the sealant must be removed and the sealing area cleaned. To clean the sealing area, use silicone gasket
remover and metal surface prep. Follow the directions on the packaging. Allow to dry until there is no sign of wetness, or 4 minutes, whichever is
longer. Failure to follow this procedure can cause future oil leakage.
Apply silicone gasket and sealant at the engine front cover-to-cylinder block sealing surface.
6. Install the oil pan gasket and the oil pan and loosely install the 18 bolts.
7. Tighten the bolts in 3 stages, in the sequence shown.
^
Stage 1: Tighten to 2 Nm (18 inch lbs.).
