F 250 4WD Super Duty V10-6.8L VIN Y (2006)
12. CAUTION: Only use hand tools when removing the transmission mount-to-crossmember nuts or damage to the transmission mount can occur.
Install the transmission mount-to-crossmember nuts.
^
Tighten to 103 Nm (76 ft. lbs.).
13. Install the transmission cooler tube support bracket and the nut.
^
Tighten to 10 Nm (89 inch lbs.).
14. Install the 4 exhaust manifold flange nuts.
^
Tighten to 40 Nm (30 ft. lbs.).
15. If the vehicle is equipped with TSS and turbine/OSS, remove the plugs and install the sensors in the transmission.
16. Install the starter. For additional information, refer to Starting System.
17. Install the generator. For additional information, refer to Alternator.
18. Install the cooling fan shroud. For additional information, refer to Cooling System.
19. Install the air cleaner outlet tube. For additional information, refer to Fuel Delivery and Air Induction.
20. Fill the crankcase with clean engine oil.
