F 250 4WD Super Duty V10-6.8L VIN Y (2006)
4. Remove the pulley snap ring.
5. Remove the A/C clutch pulley.
1
Install the special tool.
2
Remove the A/C clutch pulley.
6. CAUTION: Do not use air tools. The A/C clutch field coil can be easily damaged.
Remove the A/C clutch field coil.
1
Install the special tool on the nose opening of the A/C compressor.
2
Install the special tool.
3
Remove the A/C clutch field coil.
Installation
1. NOTE: If installing a new A/C compressor, the A/C clutch components should be reused unless obvious signs of damage are found. If excessive
grooving is found, a new A/C clutch disc and hub and A/C compressor pulley must be installed together. Otherwise, each component can be
installed individually where needed.
Visually inspect the A/C clutch disc and hub, A/C compressor pulley and A/C clutch field coil for damage.
-
Inspect for physical damage, including cracked or melted components or discoloration due to excessive heat.
-
Inspect for excessive wear, including grooving in the A/C clutch disc and hub or A/C compressor pulley that is more than fingernail depth.
-
Inspect for roughness in the A/C compressor pulley bearing.
2. Clean the A/C clutch field coil and the pulley bearing mounting surfaces.