F 250 4WD Super Duty V10-6.8L VIN Y (2006)
15. Position the wheel hub assembly in a vise with protective caps and remove the 4 studs using 2 mounting nuts.
Installation
All vehicles
1. Position the wheel hub assembly in a vise with protective caps and install the 4 studs using 2 mounting nuts.
2. NOTE: Any time the wheel hub is removed for any reason, a new O-ring seal must be installed. Failure to do so can cause a vacuum leak and loss
of 4-wheel drive operations.
Install a new wheel hub assembly O-ring seal.
Vehicles with ABS
3. Position the wheel speed sensor and install the bolt.
^
Tighten to 18 Nm (13 ft. lbs.).
All vehicles
4. If removed, position the brake disc shield.
5. NOTE: Apply a coat of grease to the O-ring area of the wheel hub assembly before installation.
Position the wheel hub assembly and install the 4 nuts.
^
Tighten to 180 Nm (133 ft. lbs.).
All vehicles
6. Install the snap ring.
7. NOTE: Any time the hub lock is removed, a new O-ring seal must be installed. Failure to do so can cause a vacuum leak and loss of 4-wheel