F 250 4WD Super Duty V10-6.8L VIN Y (2006)
Air Bag: Service and Repair
Driver Air Bag Module
DRIVER AIR BAG MODULE
Removal and Installation
WARNING:
-
If replacing a deployed air bag module, always replace the air bag electronic crash sensor (ECS) module.
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
Carry a live air bag module with the air bag and trim cover pointed away from your body. This will reduce the risk of injury in the event
of an accidental deployment.
-
Do not set a live air bag module down with the trim cover face down. This will reduce the risk of injury in the event of an accidental
deployment.
-
After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generant combustion that is
irritating to the skin. Wash your hands with soap and water afterwards.
-
Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
-
Air bag modules with discolored or damaged trim covers must be replaced, not repainted.
-
To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a SRS fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
