F 250 4WD Super Duty V10-6.8L VIN Y (2006)
Seat Belt: Service and Repair
Removal and Installation
Safety Belt - Front Bench Seat
SAFETY BELT - FRONT BENCH SEAT
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensor (BTS), if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
NOTE: Center safety belt buckle and tongue shown, others similar.
All seats
1. Remove the utility tray, if required.
Driver seat
2. Disconnect and detach the driver safety belt buckle switch electrical connector.
All seats
3. Remove the bolt and the affected safety belt buckle.
-
To install, tighten to 40 Nm (30 lb-ft).
4. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
5. Check the restraint system for correct operation.
Safety Belt - Front 40/20/40 Seat, Center
SAFETY BELT - FRONT 40/20/40 SEAT, CENTER
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensor (BTS), if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
