F 250 4WD Super Duty V10-6.8L VIN Y (2006)
3
Remove the upper safety belt web guide.
12. Remove the nut and the safety belt anchor.
13. NOTE:
-
If reusing the safety belt retractor, do not allow safety belt to completely recoil back into the retractor.
-
Safety belt retractors are specific to LH or RH seats and are not interchangeable.
Remove the safety belt retractor.
1
Remove the bolt.
2
Remove the safety belt retractor through the back of the seat.
-
Route out the safety belt, guide, tongue and anchor.
Installation
All seats
1. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
Route the safety belt anchor, tongue, web guide and safety belt up through the opening at the safety belt guide.
