F 250 4WD Super Duty V10-6.8L VIN Y (2006)
7. Remove the RH crossmember bolts and nuts.
8. Remove the LH crossmember bolt, nut and the crossmember.
1
Remove the bolt and nut.
2
Remove the crossmember.
9. Lower the transmission enough to gain access to the turbine shaft speed (TSS) sensor and intermediate shaft speed sensor.
10. Disconnect the TSS and intermediate shaft combination speed sensor electrical connector.
NOTE: Prior to removing the speed sensor, make sure that the area around the sensor is free of foreign material to prevent contamination of the
transmission.
11. Remove the TSS and intermediate shaft combination speed sensor.
1
Remove the bolt.
2
Remove the intermediate shaft and turbine shaft combination speed sensor.
INSTALLATION
1. Install the intermediate shaft and turbine shaft combination speed sensor.
1
Lubricate the O-ring and install the intermediate shaft and turbine shaft combination speed sensor.
2
Install the bolt. Tighten to 9 Nm (80 lb-in).
2. Connect the TSS and intermediate shaft combination speed sensor electrical connector.