F 250 4WD Super Duty V10-6.8L VIN Y (2006)
3. If equipped, remove the ball joint grease fitting.
4. Remove the ball joint boot.
5. Using the special tools, remove the ball joint.
Installation
1. Position the ball joint into the bracket.
2. CAUTION: The grease fitting must be removed from the ball joint prior to installation or damage to the grease fitting can occur.
CAUTION: The ball joint is installed with the dust boot attached to the ball joint. Do not damage the ball joint boot during installation.
Using the special tools, install the ball joint.
3. If removed, install the ball Joint grease fitting.
4. Install the track bar.
