F 250 4WD Super Duty V10-6.8L VIN Y (2006)
Shift Solenoid: Testing and Inspection
Pinpoint Tests - OSC Equipped Vehicles
Special Tool(s)
NOTE: If equipped, turn the power take-off (PTO) unit off for correct test results. For a description of PTO operation, refer to Transmission
Electronic Control System. On-Board Diagnostic is not accessible when the PTO unit is in operation. Shift solenoid B (SSB) is on when the PTO is in
operation.
Any time an electrical connector or solenoid body is disconnected, inspect the connector for terminal condition, corrosion and contamination. Also
inspect the connector seal for damage. Clean, repair or install a new connector as required.
Solenoid Pre-Diagnosis
Use the charts when carrying out the Pinpoint Tests.
