F 250 4WD Super Duty V10-6.8L VIN Y (2006)
Valve Body: Service and Repair
Internal Harness Service
Internal Harness Service
Material
Removal
1. Remove the solenoid body assembly.
2. Disconnect the internal wiring harness.
1
Remove the 2 screws.
2
Disconnect the transmission fluid temperature sensor electrical connector.
3
Disconnect the solenoid electrical connectors.
3. Remove the bulkhead connector O-ring seal.
4. Lift the tab twisting the bulkhead connector, push it through the solenoid body and remove the wire harness.
Installation
1. Push the bulkhead connector through the transmission solenoid body, twist it to lock it in place.
