F 250 4WD Super Duty V10-6.8L VIN Y (2006)
^
Coat the outer diameter of the new seal with gasket and trim adhesive.
2. Install the transfer case.
Vehicles with 2-wheel drive
3. Using the special tool, install a new output oil seal.
^
Coat the outer diameter of the new seal with gasket and trim adhesive.
4. Apply Threadlock 262 to the threads of the transmission flange locknut. Using the special tools, install the transmission flange.
^
Tighten to 330 Nm (244 ft. lbs.).
All vehicles
5. Connect the rear driveshaft.
