F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
Antenna Cable: Service and Repair
CABLE - RADIO ANTENNA LEAD-IN
REMOVAL
1. Remove the antenna base.
2. Position the RH front fender splash shield away from the bulkhead.
1
Remove the two nuts.
2
Remove the screws.
3
Remove the pin-type retainers.
4
Position the RH front fender splash shield away from the bulkhead.
3. Remove the RH cowl side trim panel.
1
Remove the pin-type retainers.
2
Remove the RH cowl side trim panel.
4. Route the new radio antenna lead-in cable into the passenger compartment.
1
Unseat the old radio antenna lead-in cable grommet from the bulkhead.
2
Route the new radio antenna lead-in cable into the passenger compartment.
5. Remove the radio chassis.
6. NOTE: This vehicle uses a radio antenna lead-in cable that is attached to the instrument panel reinforcement and the defroster air duct. Do not
remove the old radio antenna lead-in cable from the vehicle.
Remove the old radio antenna lead-in cable connectors to avoid rattles or identification problems.