F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
6. Remove the two bolts and remove the front seat adjuster.
7. CAUTION: Do not damage the plastic pivot bushing when removing the seat backrest.
Pull the front seat backrest away from the seat hinge and feed the lumbar cable and heating element wire through the seat cushion opening.
Separate the seat cushion from the seat backrest.
INSTALLATION
1. To install, reverse the removal procedure.
With Seat Integrated Restraints
FRONT SEAT CUSHION - WITH SEAT INTEGRATED RESTRAINTS (SIR)
REMOVAL
WARNING:
-
Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an airbag module.
This will reduce the risk of injury in the event of an accidental deployment.
-
After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generated combustion that is
irritating to the skin. Wash your hands with soap and water afterwards.
-
The safety belt buckle pretensioner and safety belt retractor pretensioner are pyrotechnic devices. Always wear safety glasses when
repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner.
-
The safety belt buckle pretensioner and safety belt retractor pretensioner are pyrotechnic devices. Never probe pretensioner electrical
connectors. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
All seats
1. WARNING: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing
or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or
striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood
latches.
Refer to the appropriate component or system to determine location of the front air bag sensors.
The side impact sensors are located at or near the base of the B-pillar.
To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect
auxiliary batteries and power supplies (if equipped).
Disconnect the battery ground cable and wait at least one minute.
