F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
5. Remove the two screws securing the lumbar adjustor control to the seat track riser.
-
Push lumbar adjuster control inward to provide clearance for trim panel removal.
6. Pull the rearward lower corner of the side shield to disengage the metal retaining clip.
7. CAUTION: Bend the side shield slightly to insure the shield is not scratched by the recliner lever.
Remove the side trim cover.
8. Disconnect the seat control switch electrical connector.
9. Remove the two screws on the seat control switch.
INSTALLATION
1. Position the seat control switch and install two screws.
