F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
5. Remove the banjo bolt. Remove and discard the copper washers
-
Prior to installing the banjo bolt install new copper washers.
6. Remove the rear disc brake caliper.
7. To install, reverse the removal procedure.
8. Bleed the brake system.
Caliper Disassembly and Assembly
Caliper
Disassembly
1. Remove the rear disc brake caliper.
2. Drain remaining brake fluid from the rear disc brake caliper.
3. Secure the rear disc brake caliper.
4. Remove the caliper pistons.
1. Place a block of wood between the caliper bridge and the caliper pistons.
2. Apply low air pressure to the fluid port in the rear disc brake caliper.
3. Force out the caliper pistons to the block of wood.
4.Remove the block of wood and the caliper pistons.
Brake Caliper Anchor Plate
Brake Caliper Anchor Plate
Removal
1. Remove the brake pads.
