F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
Brake Switch (Cruise Control): Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
WARNING: BRAKE FLUID CONTAINS POLYGLYCOL ETHERS AND POLYGLYCOLS. AVOID CONTACT WITH EYES.
WASH HANDS THOROUGHLY AFTER HANDLING. IF BRAKE FLUID CONTACTS EYES, FLUSH EYES WITH RUNNING
WATER FOR 15 MINUTES. GET MEDICAL ATTENTION IF IRRITATION PERSISTS. IF TAKEN INTERNALLY, DRINK
WATER AND INDUCE VOMITING. GET MEDICAL ATTENTION IMMEDIATELY.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it
with water.
2. Disconnect the deactivator switch electrical connector.
3. Remove the deactivator switch.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: After the deactivator switch is installed, it is necessary to bleed the brake system.
