F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
26. NOTE: The idle air control valve is shown removed for clarity.
Install the throttle body adapter
^
Position a new throttle body adapter gasket.
^
Position the throttle body adapter.
^
Install four bolts and tighten in two stages.
^
Stage 1: Tighten to 8 - 10 Nm (71 - 89 inch lbs.).
^
Stage 2: Tighten an additional 85 - 95 degrees.
27. NOTE: The EGR valve is shown removed for clarity.
If equipped, connect the EVR solenoid electrical and vacuum harness.
28. If equipped, connect the EGR valve vacuum line.
29. If equipped, install the EGR valve-to-exhaust manifold tube.