F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
7. Loosely install the bolts then tighten the bolts in the two stages, in the sequence shown.
^
Stage 1: Tighten to 20 Nm (15 ft. lbs.).
^
Stage 2: Tighten an additional 60 degrees.
8. Connect the crankshaft position sensor electrical connector.
9. NOTE: The front lower hole in the power steering pump is not used.
Position the power steering pump and install the bolts.
10. Install the drain plug.
11. Lower the vehicle.
12. Install the valve covers.
13. Install the water pump.
14. Install the radiator.
15. Fill the engine with clean engine oil.
16. Connect the battery ground cable.
