F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
5. Loosen the clamps and remove the intercooler tube (if equipped).
6. Disconnect the heater hose coupling from the underbody auxiliary heater lines.
All vehicles
7. Disconnect the manifold and tube assembly.
^
Discard the O-ring seal.
8. Detach the evaporator inlet from the clip.
9. Remove the suction accumulator/drier bolts and remove the suction accumulator/drier.
INSTALLATION
1. To install, reverse the removal procedure.
^
Install new O-ring seals lubricated in clean PAG oil.
