F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
8. Reattach the ABS wiring harness and position the fender splash shield in the wheel well.
9. Install the vacuum reservoir retaining nuts.
10. Install the fender splash shield four screws, three bolts, and three pin-type retainers.
11. Install both RH wheels.
12. Lower the vehicle.
13. Fill the cooling system.
Heater Outlet Line
REMOVAL
CAUTION: It may be necessary to cut the underbody auxiliary line(s) being serviced into sections to facilitate removal. Make sure to correctly identify
the line(s) being serviced before carrying out any cutting of the line(s).
NOTE: Lay out the new lines in vehicle position to assist in the installation.
1. Drain the cooling system.
2. Raise and support the vehicle.
3. Remove the front and rear RH wheels.
