ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Driver/Vehicle Information Display|Testing and Inspection > < Information and Message Center
Page 1
background image

Driver/Vehicle Information Display: Description and Operation
Principles of Operation (How Does It Work?)

PRINCIPLES OF OPERATION

NOTE: The distance to empty (DTE) display may be inaccurate if the vehicle is started while parked on an incline.

Fuel fills of less than 22.7 liters (six gallons) may not be detected by the message center.

The message center displays:

-

compass direction

-

DTE

-

average (AVG) fuel economy

-

outside air temperature

The message center display may be turned off by use of the mode button.

The message center inputs are:

-

fuel level sensor data

-

data output line (DOL) fuel flow data from the PCM

-

ISO-9141 diagnostic link

-

vehicle speed signal

-

dimming signal

-

outside temperature sensor

Outside Air Temperature

If the outside temperature falls below 3.3°C (38°F), the display will alternate from "ICE" to the outside temperature at a two second rate for one minute
.

he outside air temperature reading can be affected by engine heat when the vehicle is idling or has been off for less than two hours. The compass and
outside temperature will limit the increase of the displayed temperature to one degree per minute at very low speeds or immediately after the ignition is
turned on. After two minutes at a sustained speed of at least 53 km/h (33 mph), effects of engine heat are minimal and the compass will display the
current outside temperature reading. Temperature decreases are always updated immediately.

If the outside air temperature sensor is short or open circuited, then the display will show 60°C (140°F) or -40°C (-40°F) respectively in place of
temperature.

Average (AVG) Fuel Economy - Resetting

NOTE: Only the AVG fuel economy can be reset. The DTE display cannot be reset.

The AVG fuel economy display is resettable. To reset, the ignition switch must be in the RUN position (with or without the engine running) and the
message center must be in the AVG fuel economy mode.

Depress and hold both buttons while in AVG fuel economy mode for a period of two to three seconds until AVG is displayed. Release both buttons to
reset AVG fuel economy.

If the vehicle is parked while resetting, the AVG fuel economy will display 99.9 (metric mode) or 0.0 (English mode).

Driver/Vehicle Information Display|Testing and Inspection > < Information and Message Center